CB Sols Flooring
CB Sols
Coverings · La Rochelle
Language
FRENES
ServicesFor businessesFor homeownersArchitectsProjectsShowroomBrandsAboutAreas
06 85 05 28 80Free quote
CB Sols→FAQ
Vinyl Flooring

Can you lay vinyl in a bathroom (warmer, less slippery)?

Short answer

Yes. Professional sheet vinyl with heat-welded seams (Gerflor Taralay, objectflor) is 100% watertight, anti-slip R10 or R11 depending on the range, and noticeably warmer than tiles. It is an excellent alternative for a private bathroom.

Why vinyl makes sense in a bathroom

Modern vinyl has nothing in common with low-end lino. The professional ranges we lay in bathrooms offer three key advantages over tiles:

1. Thermal comfort: vinyl is noticeably less cold to bare feet than tiles or stone. Its thermal conductivity is about three times lower. Ideal stepping out of the shower or bath.

2. Safety: the bathroom ranges are rated R10 or R11 (anti-slip in the presence of water). For comparison, standard tiling is R9 or less once wet.

3. Perfect watertightness: laid in sheet (rolls) with heat-welded seams, vinyl is 100% watertight. No cement joints that blacken over time, no risk of seepage under the shower.

The ranges suited to a private bathroom

For a private bathroom, two main options:

Sheet vinyl (rolls): the safest solution, especially with a walk-in shower. Gerflor Taralay Premium or objectflor expona: 2-3 mm thick, R10/R11, invisible heat-welded seams, lifespan 15-28 years.

Click LVT planks: for a bathroom with a shower tray or bath (no walk-in shower), you can use premium LVT planks. Very realistic wood or stone look, faster laying. Gerflor Creation 55 or objectflor LooseLay: lifespan 20+ years, but watertightness depends on the quality of the junctions.

We assess at the visit which solution is best suited to your bathroom.

Substrate preparation and laying

A private bathroom is prepared rigorously:

1. Any removal of the old tiling if too uneven (rare; vinyl is often laid over it after a levelling compound) 2. A P3 fibre-reinforced surfacing compound to neutralise the joints and create a perfectly flat surface (2 mm tolerance under a 2 m straightedge) 3. A suitable bonding primer 4. Glued-down laying of the sheet vinyl or floating click-laying of the LVT 5. Heat welding of the seams (sheet vinyl only) with a weld cord matched to the colour 6. Finishes: coved skirting (5 to 10 cm up the wall) or a fitted skirting, sanitary silicone seal around the shower/bath

Allow 1 to 2 days depending on the area. The bathroom can be used 24 hours after laying.

Related questions
Laying Technique
Can carpet be laid over existing tiles?
Read →
Vinyl Flooring
What are the standards for vinyl flooring in a professional kitchen?
Read →
Your project

A question about your project?

CB Sols replies within 24h, free quote within 48h

Free quote06 85 05 28 80