CB Sols Flooring
CB Sols
Coverings · La Rochelle
Language
FRENES
ServicesFor businessesFor homeownersArchitectsProjectsShowroomBrandsAboutAreas
06 85 05 28 80Free quote
CB Sols→FAQ
Laying Technique

Can carpet be laid over existing tiles?

Short answer

Yes, under conditions. The tiling must be flat (2 mm tolerance under a 2 m straightedge), clean, with no loose tiles and sound joints. A surfacing levelling compound is mandatory.

The conditions for laying over tiles

Laying carpet over tiles is technically possible, but the substrate must meet several criteria:

1. Flatness: the maximum tolerance is 2 mm under a 2-metre straightedge. Bowed or cracked tiles, or over-proud joints, will show through the carpet and create zones of premature abrasion.

2. Soundness: every tile must be perfectly bonded. A hollow tile (one that sounds hollow when tapped) must be re-laid. A carpet over a loose tile will eventually come loose too, or even create a dangerous step.

3. Cleanliness: the tiling must be degreased and free of any adhesive or residue that would prevent bonding. CB Sols carries out a clean and a bonding primer if needed.

4. Joints: sound cement joints are acceptable. Cracked, loose or very wide joints must be redone. Over-proud joints can be mechanically ground down.

Fixing methods

Two fixing methods are possible for carpet over tiles:

Adhesive (the most common method in professional work): a suitable floor adhesive is applied only over the levelling compound laid beforehand. It is the strongest and most durable method, recommended for high-traffic spaces and heavy carpets.

Gripper rods: gripper strips are nailed or glued around the perimeter of the room. The carpet is stretched over them. This method is possible but less recommended over tiles, as the anchoring of the strips is less secure than over concrete.

CB Sols determines the best method when quoting, after assessing the type of tiling and the intended use.

Do the tiles need to be removed?

No, in most cases. Removing tiles is slow, costly, generates a lot of rubble and risks damaging the substrate. Unless the tiling is in very poor condition (multiple loose tiles, deep cracking), it is better to lay the carpet over it after preparation.

The only situation where removal is essential: if the build-up of levels (old tiling + any previous covering + new carpet) creates an unacceptable step relative to door thresholds or adjoining areas.

CB Sols systematically assesses the level build-up when quoting to anticipate these problems.

The surfacing levelling compound: essential

Even over clean, flat tiling, the joints create relief (usually 1 to 3 mm) that shows and wears prematurely under the carpet. The solution: a fine surfacing (self-levelling) compound applied over the whole tiling to create a perfectly flat surface.

This compound costs between 8 and 25 €/m² (standard P3 6-10 €/m², fibre-reinforced 12-30 €/m² over wood or heavy thicknesses). It dries in 4 to 48 hours before covering depending on the product. CB Sols always checks flatness after the compound before moving to the laying.

For projects where speed is crucial, there are ultra-fast-setting compounds (walkable in 30 minutes).

Related questions
Carpet
What is the difference between contract carpet and residential carpet?
Read →
Carpet
What is the lifespan of a professional carpet?
Read →
Your project

A question about your project?

CB Sols replies within 24h, free quote within 48h

Free quote06 85 05 28 80